Blast Powercore Accessories

Installation Instructions

PDF-000383-01 R01

15 November 2019

Must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.
Before installing this product, please visit the product page at www.colorkinetics.com for the latest version of the installation instructions. Due to continuous improvements and innovations, installation instructions may change without notice.

  1. Confirm all components received

  2. Clean and dry housing face, glass surface, and Spread Lens. Use mild, non-abrasive cleaner.

  3. Determine positioning of Spread Lens and other accessories

    Multiple accessory stacking order
Fastener Lengths for Blast Accessories
Single accessory configurations

Spread Lens and Trim Ring

Louver

Glare Shield - Half

Glare Shield - Full

Rock Guard

  1. Lock Spread Lens and Trim Ring

Designation face up
Six screw torque sequence
Use only 4 mm hex hand tools to lock luminaires (customer supplied). Torque setting: 3.4 N-m (30 In-lbs) maximum.
  1. Fasten last accessories with four screws

Complete accessory installation before final aiming of fixture.
Four screw torque sequence
Use only 4 mm hex hand tools to lock luminaires (customer supplied). Torque setting: 3.4 N-m (30 In-lbs) maximum.
Do not attempt to install or use a luminaire until you read and understand the installation instructions and safety labels.
Do not use a luminaire if the lens, housing, or power cables are damaged.
Luminaires have line voltage risk of shock and no user serviceable parts. Do not attempt to open them.

© 2019 Signify Holding. All rights reserved. Specifications are subject to change without notice. No representation or warranty as to the accuracy or completeness of the information included herein is given and any liability for any action in reliance thereon is disclaimed.

www.colorkinetics.com


How Did We Do?


Powered by HelpDocs